Manual Override - Harmar Mobility AL350 Installation & Owner's Manual

Operating Your Lift

MANUAL OVERRIDE

In the event of a power failure, for example
if your car battery dies, your lift can still
operate using the Manual Override system.
1. Unplug Power to the Lift.
Figure 8-1
2. Remove the cap
[Figure 8-2]
3. Insert a 3/8" socket wrench into the
actuator
and rotate the Hex Shaft. [Figure 8-3]
Figure 10-2
Figure 8-2
8
SECTION 1 : OWNER
[Figure 8-1]
on top of the motor.
REMOVE
3/8"
Figure 8-3
| www.harmar.com | 800-833-0478
Disconnect power from lift
BEFORE
WARNING
override.
IMPORTANT!
You MUST unplug the two-connector plug BEFORE
any attempt to use the Manual Override. Failure to
do so result in serious injury.
4. Turn COUNTER-CLOCKWISE to LOWER
the platform. [Figure 8-4]
5. Turn CLOCKWISE to RAISE
[Figure 8-4]
Turn COUNTER -
CLOCKWISE
to LOWER platform.
attempting manual
the platform.
Turn CLOCKWISE
to RAISE platform.
Figure 8-4