Edge Guide Removal - Epson STYLUS COLOR 3000 Service Manual

Edge Guide Removal

See the following page for installation notes.
1. Remove the upper housing (See page 3-4).
2. Remove the printer mechanism (See page 3-10).
3. Release the joints for the slide covers on the paper feed shaft and the edge guides.
4. Disconnect the connector cable for the PQ (Paper Quantity) sensor located on the right side of the right
edge guide.
5. Remove the screw (CBS, 3×8) securing the ink cartridge holder to the middle frame so that the flange nut
under the cartridge holder will be removed easily in the next step.
6. Remove two flange nuts (M4) securing the edge guide to the left frame and middle frame. Then remove
the edge guide.
Paper Feed Shaft
Flange Nut (M4)
When attaching the edge guide to the printer mechanism, connect the edge guide rack to the
pinion on the damper.
EPSON Stylus Color 3000 Service Manual
Slide Covers
Figure 3-21. Edge Guide Removal
REMINDER
CBS Screw (3×8)
EPSON Stylus COLOR 3000
Cartridge Holder
Flange Nut (M4)
Rotary Damper
Edge Guide
3-23