Clearing A Material Blockage; Turning The Appliance Off; Overheating Protection - UNITED OFFICE UAVS 300 A1 Operating Instructions And Safety Instructions

Clearing a material blockage

♦ Move the REV/OFF/AUTO/FWD switch
if the material being shredded causes a jam . The appliance now goes into
reverse and the material is ejected .
♦ Alternatively, move the REV/OFF/AUTO/FWD switch
("forward") position if the material causes a blockage . The appliance is now
in forwards operation and the material that is being shredded is pulled in
again .
♦ Move the REV/OFF/AUTO/FWD switch
the jammed material has been ejected .

Turning the appliance off

NOTE
► We recommend that you switch off the appliance and let it cool down for
about 30 minutes after 3 minutes of operation to prevent overheating .
♦ Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
the OFF position . The power lamp

Overheating protection

This appliance is fitted with overheating protection . If the motor overheats due to
overloading, the appliance switches itself off automatically . The overheat lamp
lights up permanently red until the motor has cooled down sufficiently .
If this occurs, do the following:
WARNING! – RISK OF INJURY!
► Pull the power plug out of the power socket to prevent unintended starting
of the appliance .
♦ Switch the appliance off by moving the REV/OFF/AUTO/FWD switch
the middle OFF position .
♦ Empty the waste collectors
♦ Allow the appliance to cool down for about 30 minutes .
♦ Replace the plug in the mains power socket .
♦ Switch the appliance on by moving the REV/OFF/AUTO/FWD switch
to the AUTO position . The overheat lamp
appliance has cooled down sufficiently .
■ 26 │
GB │ IE
8 to the REV ("reverse") position
8 to the OFF position as soon as
6 goes out .
w e
/ .
7
no longer lights up once the
8 to the FWD
8 to
7
8
to
8
UAVS 300 A1