Shifting Paper In The Waste Collector; Clearing A Material Blockage; Turning The Appliance Off - UNITED OFFICE UAVK 180 A1 Operating Instructions Manual

Shifting paper in the waste collector

The paper may fall unevenly into the waste collector
on the underside of the cutter attachment
stop, even though the waste collector
The power/bin full LED
WARNING! – RISK OF INJURY!
► Pull the power plug out of the power socket to prevent unintended starting
of the appliance.
♦ Remove the cutter attachment
integrated carrying handles
♦ Even out the paper.
♦ Place the cutter attachment
carrying handles
♦ Slide the AUTO/OFF/REV switch
bin full LED
use.

Clearing a material blockage

In a paper jam, the paper is caught in the cutting blades.
During automatic feeding, the appliance will beep until the paper jam is cleared.
During manual feeding
paper jam has been cleared.
♦ Slide the AUTO/OFF/REV switch
material being shredded gets stuck. The appliance now goes into reverse
and the material is ejected.
The power/bin full LED
♦ Pull the material being cut out of the appliance and then slide the AUTO/
OFF/REV switch
The appliance is now ready for use.
Turning the appliance off
NOTE
► Regularly remove any residue left in the cutting blades with a suitable
object (e.g. brush or tweezers). Ensure that the appliance is unplugged
before doing this!
♦ Switch the appliance off by sliding the AUTO/OFF/REVswitch
OFF position. The power/bin full LED
UAVK 180 A1
is not full.
flashes blue and beeps.
from the waste collector
.
onto the waste collector
so that the mains cable protrudes to the rear.
continuously lights up blue. The appliance is now ready for
, the overheat/overload LED
lights up blue continuously.
to AUTO.
and trigger the sensor
. This will cause the appliance to
using the integrated
to the AUTO position. The power/
flashes red until the
to the REV (reverse) position if the
goes out.
GB │ IE
using the
to the
│
21 ■