Operation; Using Auto Mode; Clearing A Material Blockage - UNITED OFFICE UAV 190 A1 Operating Instructions Manual

Operation

NOTE
► As every shredder is tested for functionality after manufacture, it is possible
that you may find paper residue in the cutting blades.
● Place the shredder on a suitable container:
place the broad end of the appliance on the edge of the container. Then pull
out the telescopic arm
● Insert the plug into a mains power socket.
Operation
You can shred up to 6 sheets (80 g/m
CAUTION! MATERIAL DAMAGE!

Using auto mode

● Set the switch
as soon you insert paper and switches off automatically once no further
paper is inserted.
NOTE
► Always insert smaller pieces of paper into the middle of the cutter opening
This is where the contact that starts the cutting process is located.

Clearing a material blockage

● Move the switch
shredded causes a blockage.
The appliance now goes into reverse and the paper that is being shredded
is ejected.
● Pull the paper out of the appliance, then set the switch
● The appliance is now ready for use.
UAV 190 A1
until it sits securely on the other edge.
Remove all paper clips or staples before inserting the paper
into the cutter opening
be damaged.
to the "AUTO" for shredding. The motor starts automatically
to the "REV" ("reverse") position if the paper being
2 paper) at the same time.
. The cutting blades might otherwise
GB │ IE │ NI
.
to "AUTO".
│
5 ■