Clearing A Material Blockage; Switching The Appliance Off; Note Regarding Overheating Of The Appliance - UNITED OFFICE UAV 190 B2 Operating Instructions Manual

Clearing a material blockage

● Move the switch 1 to the "REV" ("reverse") position if the paper being
shredded causes a blockage .
The appliance now goes into reverse and the paper that is being shredded
is ejected .
● Pull the paper out of the appliance, then set the switch 1 to "AUTO" .
● The appliance is now ready for use .
NOTE
► Reverse mode is solely for clearing paper jams . Do not use it for removing
documents that are already half shredded and are not causing a jam .

Switching the appliance off

● To switch the device off, push the switch 1 to the "OFF" position .
● If you do not intend to use the appliance for an extended period, remove the
plug from the power socket .

Note regarding overheating of the appliance

If the appliance overheats due to overloading, the overheat LED 5 lights up as
soon as a paper sheet touches the contact which starts the cutting process . The
appliance stops .
► Remove the power plug from the wall socket to avoid unintended restarting
of the appliance .
● Place the switch 1 in the "OFF" position .
● Empty the container .
● Allow the appliance to cool until it has cooled to room temperature .
● Put the mains plug back into the socket .
● Switch the appliance on by moving the switch 1 into the "AUTO" position .
■ 36 │
GB │ MT
WARNING – RISK OF INJURY!
UAV 190 B2