Olympus MVX10 Instructions Manual page 47

@
Fig. 44
Fig. 45
@
Fig. 46
Attaching the Lamp Housing
1. Using the Allen screwdriver, loosen the two clamping screws @ on
the lamp housing mount hole.
2. Fit the lamp housing all the way as shown in Fig. 44.
3. Tighten the clamping screws @ using the Allen screwdriver.
# The surroundings of the lamp housing become very hot during
and after operation. When installing the microscope system,
ensure sufficient space around the lamp housing, particularly
above it. Also do not mount the lamp housing obliquely.
11
Mounting (Removing) the Stage Plate
Place the stage plate (white, black on back side) or a stage glass into the
mounting hole on the base.
To remove, press the stage plate at the edge nearest to the pillar with
your fingertip. The opposite end will rise from the base so the stage plate
can be picked up easily.
Attaching the Specimen Holder
}Use the specimen holder when a specimen is hard to be fixed.
Insert the specimen holder @ into the two holes ² on the top surface of
the base.
²
MVX10
(Fig. 45)
43