Olympus MVX10 Instructions Manual page 6

Caution indications
Caution indications are affixed at parts where special precaution is required when handling and using the microscope.
Always heed the cautions.
Caution indication
positions
1
Getting Ready
}This instruction manual pertains only to the operating procedures of the Research Macro Zoom System. Also read the
instruction manuals for the modules used in combination with the microscope system so that you can understand the
comprehensive operating procedures of the system.
Fig. 1
2
· Lamp housing
(U-LH100HG, U-LH10HGAPO)
· Power supply unit
1. A microscope is a precision instrument. Handle it with care and avoid
subjecting it to sudden or severe impact. Also be careful in handling
the limiting or stopper mechanisms because an excessive force may
destroy them.
2. Do not use the microscope where it is subjected to direct sunlight, high
temperature and humidity, or vibration.(For the operating environment,
see Section 8, "SPECIFICATIONS" on page 22.)
3. To prevent the microscope body from turning over, its pivot angle
must be limited to 30° and the tilt angle of the desk surface must
be limited to 5° as shown in Fig.1.
4. Care is required when using an auxiliary pillar (SZH-P400/P600) because
it increases the height of the microscope body and makes it unstable.
5. To adjust the microscope body height, be sure to hold the focusing
assembly with one hand and then loosen the focusing assembly
clamping knob @. (Fig. 1)
(Use the drop prevention collar (SZX-R) to prevent a hazard from
occurring.)
Be careful not to pinch your finger during adjustment.
@
[High temperature caution]
[High voltage caution]