Connect The Ap; Connect The Ap For Link Aggregation - Watchguard AP325 Hardware Manual

Connect the AP

To power on and connect the AP325 to the network with PoE:
1. Connect one end of the network interface cable to the LAN1 PoE port on the AP325.
2. Connect the other end of the network interface cable to an Ethernet jack that provides PoE power.
To connect the AP325 to the network and to power on the AP325 with a power adapter:
1. Connect one end of the network interface cable to the LAN1 PoE port on the AP325.
2. Connect the other end of the network interface cable to an Ethernet network jack.
3. Plug the power adapter cable into the 12V DC power receptacle on the back of the AP325.
4. Plug the power adapter into an 100V-240V 50/60 Hz AC power source.

Connect the AP for Link Aggregation

With WatchGuard Wi-Fi Cloud, you can use both Ethernet ports of the AP325 for link aggregation that
enables these ports to logically merge into a single link for higher aggregate bandwidth.
You must enable link aggregation in a device template for the AP325, and link aggregation must also be
enabled on your network switch for the two ports connected to your AP. Both links should use CAT6
Ethernet cabling.
Make sure that PoE power is supplied to the indicated first Ethernet port labeled LAN1 (PoE) on the AP325.
The second Ethernet port is not supported when the AP is managed locally by a
Gateway Wireless Controller on a Firebox.
WatchGuard Technologies, Inc.
WatchGuard AP325 Hardware Guide
11