Connect The Ap; Connect The Ap For Link Aggregation - Watchguard AP125 Hardware Manual

WatchGuard AP125 Hardware Guide

Connect the AP

To power on and connect the AP125 to the network with PoE:
1. Connect one end of the network interface cable to the LAN2/PoE port on the AP125.
2. Connect the other end of the network interface cable to an Ethernet jack that provides PoE power.
To connect the AP125 to the network and to power on the AP with a power adapter:
1. Connect one end of the network interface cable to the LAN2/PoE port on the AP125.
2. Connect the other end of the network interface cable to an Ethernet network jack.
3. Plug the power adapter cable into the 12V DC power receptacle on the back of the AP125.
4. Plug the power adapter into an 100V-240V 50/60 Hz AC power source.

Connect the AP for Link Aggregation

With WatchGuard Wi-Fi Cloud, you can use both Ethernet ports of the AP125 for link aggregation that
enables these ports to logically merge into a single link for higher aggregate bandwidth.
You must enable link aggregation in a device template for the AP125, and link aggregation must also be
enabled on your network switch for the two ports connected to your AP. Both links should use CAT6
Ethernet cabling.
Make sure that PoE power is supplied to the indicated Ethernet port labeled LAN2 (PoE) on the AP125.
12 WatchGuard Technologies, Inc.