Mount And Connect The Access Point; Ceiling Mount - Watchguard AP432 Hardware Manual

Mount and Connect the Access Point

Your package includes the access point, ceiling mount t-rail brackets, and wall mount screws and
spacers.
The MAC address and serial number of your access point are printed on a label on the
back of the device. Make sure you record this information before you mount the
device.

Ceiling Mount

The ceiling mount bracket is intended for use with ceilings with a t-rail system.
1. Slide the ceiling mount base into the slot on the back panel of the access point.
2. Hold the access point with one hand to reach the other hand over the t-rail sides of the bracket.
3. Attach the stationary end of the ceiling mount bracket on to the t-rail.
WatchGuard Technologies, Inc.
WatchGuard AP432 Hardware Guide
12