U-Bolt Kit - Harmar Mobility AL350 Installation & Owner's Manual

Chair Preparation
Installing U-Bolt Hardware Kit
The U-bolts are used with power chairs or
scooters that do not have a center seat post. On
this type chair, the seat is normally attached to
a tubular frame. Install the U-bolts, two on
each side, to the frame as shown. [Figure 26-1]
Ensure that the loop extends to the outside of
the chair so the user can attach the strap hooks.
26
SECTION 2 : INSTALLER
Each chair is slightly different so the U-bolt
placement will differ among models and
manufacturers. Place the U-bolts towards the
center of the seat if possible. Due to different
seat types, you may be forced to install the
U-bolts more towards the front or rear of the
seat, but we recommend attachment as close
as possible to the center of the seat.
| www.harmar.com | 800-833-0478
Figure 26-1