Harmar Mobility AL350 Installation & Owner's Manual page 16

Installation
•
If the harness is too long, coil the
excess wire and secure it to the
vehicle frame/bumper with the
supplied wire ties. [Figure 16-1]
DO NOT
CAUTION!
4. Once harness is run into the vehicle,
remove the pin's protective tubing.
5. Inspect the pin's retaining flanges.
They may have become deformed while
run through the vehicle. These are critical
to secure the pins inside the connector.
Adjust as needed.
6. Flip open end connector's jigned
retainer, insert pins as shown.
16-2]
Verify the wires can not be pulled out by
moderately pulling on the wires.
Be sure rubber seals are inside back of
connector and close the hinged retainer.
7. Plug connector into the lift.
8. LAST...attach red wire to the positive
terminal on the battery.
16
SECTION 2 : INSTALLER
cut or shorten the harness.
[Figure
[Figure 16-3]
| www.harmar.com | 800-833-0478
P r o t e
P r o t e
c t i v e
c t i v e
t u b i n
t u b i n
g
g
3
3
CORRECT
CORRECT
LETTER S A RE
LETTERS ARE
MOLDED INTO
MOLDED INTO
PLASTIC
PLASTIC
OR OR
TOP MOUNT TOP MOUNT
SIDE MOUNT SIDE MOUNT
COIL ANY EXCESS COIL ANY EXCESS
WIRE HERE WIRE HERE
DO DO NOT NOT CUT CUT
OR SHORTEN OR SHORTEN
Figure 16-1
IF NEEDED
IF NEEDED
ADJUST BY
ADJUST BY
4 PR YINGOUT
4 PRYING OUT
SLIGHT L Y
SLIGHTLY
5 5
HINGED HINGED
RE TAINER RETAINER
SEALS
SEALS
Figure 16-2
S T S T
L A L A
Figure 16-3