U-Bolt Hardware Kit - Harmar Mobility AL010 Installation & Service Manual

OUTSIDE VEHICLE LIFTS: SECTION 5
CHAIR PREPARATION

U-BOLT HARDWARE KIT

The U-bolts are used with power chairs or scooters
that do not have a center seat post. On this type of
chair, the seat is normally attached to a tubular frame.
Install the U-bolts, two on each side, to the frame as
shown. See Figure 5-3.
Seat Post
Seat Post
IT Contains
4 - 1/4" - 20 x 3 1/4" U-Bolts
8 - U-Bolt Backing Plates
16 - Split Lock Washers
16 - 1/4" - 20 Nuts
Outside Vehicle Lifts:
20
06DEC19 | P/N: 630-00106 REV A
Seat Post
Seat Post
Figure 5-3
Installation & Service Manual
Ensure that the loop extends to the outside of the
chair so the user can attach the strap hooks.
Each chair is slightly different, so the U-bolt
placement will differ among models and
manufacturers. Place the U-bolts toward the center
of the seat if possible. If your seat type requires you
to install the U-bolts more toward the front or rear of
the seat, aim to install them as close as possible to the
center of the seat.
ALA580
U-Bolt Hardware Kit