Section 2: Installer - Harmar Mobility AL350 Installation & Owner's Manual

Safety & Maintenance
CAUTION!
Drive the scooter off
in REVERSE. When the
scooter is clear of the
platform, raise the
platform by pushing up
on the UP/DOWN switch.
10
SECTION 2 : INSTALLER
MAINTENANCE
This Outside Lift is designed to be as trouble free as possible;
however, some basic maintenance will ensure that it continues
to offer reliable use for years to come.
Oil pivot points on all moving parts every 30 days.
Re-grease the inside vertical square tube every 30 days in
winter or in dirty or dusty conditions. Just lower the platform
to the ground and clean the tube with mineral spirits, WD-40,
or a good solvent. When clean, grease the square vertical tube
shaft with high grade water-resistant grease such as boat
trailer wheel bearing grease. [Figure 10-1]
Check for paint chips and touch up bare metal. Use a good
gloss black enamel or lacquer to inhibit rust. You may need to
do this more frequently if your lift is subject to salt air or road
salt in the winter.
| www.harmar.com | 800-833-0478
Figure 10-1