Step 7: Apply Power And Check The Leds; Step 8: Manage The Switch - NETGEAR MS108TUP Hardware Installation Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Smart Switch Hardware Installation Guide

Step 7: Apply power and check the LEDs

The switch does not provide an on/off power switch. The power cable connection
controls the power.
Before connecting the power cable, select an AC outlet that is not controlled by a wall
switch, which can turn off power to the switch.
To apply power:
1. Connect the plug of the DC power adapter to the DC power receptacle on the back
of the .
2. Connect the AC power cable receptacle to the power adapter.
3. Connect the AC power cable plug to a power source such as a wall socket or power
strip.
4. Check to see that the LEDs on the switch light correctly.
When you apply power, the Power LED on the switch front panel lights and the port
LEDs for attached devices light. For more information, see LEDs on page 13.
Note: After you apply power, the Power LED is blinking green while the switch starts.
When the switch completes its startup process, the Power LED turns solid green.
If the Power LED does not light, check to see that the power cable is plugged in
correctly and that the power source is good.

Step 8: Manage the switch

The switch is a plug-and-play device that starts switching as soon as you plug it into
power and your network.
After you complete the initial log-in procedure, you can configure the switch using the
local browser UI. If you are an Insight Premium or Insight Pro user, after you complete
the initial log-in procedure, you can also change the management mode so that you
can finish configuring the switch using the Insight Cloud Portal or Insight app.
Note: By default, the DHCP client of the switch is enabled. If the switch cannot get an
IP address from a DHCP server, the switch's default IP address is 192.168.0.239 and the
default subnet mask is 255.255.255.0.
Installation 27 Hardware Installation Guide