Hardware Installation; Caution Of Static Electricity - Boser HS-3200/4M Manual

Chapter-2

Hardware Installation

This chapter describes how to install the HS-3200/4M. At first, please follow
the unpacking information. The jumpers and switches setting, watchdog timer
setting, and the DiskOnChip? address selection, are also included.

2.1 Caution of Static Electricity

Your HS-3200/4M Industrial Single Board contains very sensitive electronic
components that can be easily damaged by the static electricity.
In this section, we describe the precautions that you should pay attention to
while unpacking as well as during the installation. It is very important that the
instructions to be followed correctly to avoid static damages and to
successfully install the board.
The system board can be done on a grounded anti-static mat. The operator
should be wearing an anti-static wristband, grounded at the same point as the
anti-static mat.
All inspecting the cardboard carton, extracting the system board and handling
may cause damages to your board. Be sure that there are no shipping and
handling damages on the board before processing.
After opening the cardboard carton, extract the system board and place it only
on a grounded anti-static surface component with the side up.
Again, inspect the board for damages. Press down on all the socketed IC's to
make sure they are properly seated. Do this only when the board is placed on
a firm flat surface.
Note :
You are now ready to install your HS-3200/4M Industrial Single Board.
DO NOT APPLY POWER TO THE BOARD IF IT HAS
BEEN DAMAGED.
9