Jumper Description - Boser HS-3200/4M Manual

2.5Jumper Description

This board's default jumpers are present at the factory. If you want to change
the HS-3200/4M's configuration, please follow the instructions.
A jumper switch is closed (sometimes referred to as shorted with a plastic
cap inserted over two pins of the jumper). A jumper is open with a plastic cap
inserted over one or no pin(s) of the jumper. Figure 2.2 below shows different
jumper settings which will be used in this chapter.
closed
1
1-2
Figure 2.2
open
1
2-3
13