Set Screen Contrast; Set Control Panel Language; Set Temperature Unit; Password Protection - Pentair INTELLIFLO Installation And User Manual

MENU
SETTINGS
5. Use the or
Address" and press
6. Press or arrows to change the address
number from 1-16.
7. Press to save. To cancel any changes, press
to exit without saving.
8. Press to exit.
The default setting for the LCD screen is 3. Screen
contrast levels can be adjusted from 0 to 7 units for low
or high lighting conditions.
Changes to the contrast setting do not update
instantaneously. Changes to this setting must be
saved before the contrast level changes.
1. Check that the green power LED is on.
2. Press .
3. Press to select "Settings".
4. Use the or
and press .
5. Use the or
Level."
6. Press . Screen will show current contrast
setting number. Use
number.
7. Press to save. To cancel any changes, press
to exit without saving.
8. Press the button to exit.
To access the language menu:
1. Check that the green power LED is on.
2. Press and press
3. Use the or
and press .
4. Use the or
Language and press
5. Use the or
language.
6. Press to select the control panel language. To
cancel any changes, press
7. Press to exit.
arrows to scroll to "Pump
.
(450 RPM - 1700 RPM) - Default: 450 RPM
arrow to scroll to "Device"
arrow to scroll to "Contrast
or to change
to select "Settings".
arrows and scroll to "Device"
arrows to scroll to "Select
.
arrows to choose the desired
to exit without saving.
The default setting is Fahrenheit (°F). The pump can be
set to either Celsius (°C) or Fahrenheit (°F).
1. Check that the green power LED is on.
2. Press .
3. Press to select "Settings".
4. Use the or
menu item. Press
5. Use or
Units" and press
6. Use or
Fahrenheit (°F).
7. Press to save. To cancel any changes, press
to exit without saving.
8. Press to exit.
The default setting for password protection is disabled.
When this feature is enabled, the pump display will
prompt for the password before allowing access to the
control panel and buttons.
The entered password is any combination of four (4)
digits.
The pump can always be stopped by pressing
, even when password protection is enabled.
Password protection cannot be turned back on with
while running in manual mode.
Pressing
it back to the Running Cycles Mode and run at
the next scheduled run time. If the present time is
within the scheduled run time, the pump will run the
scheduled speed.
All functions including programming are disabled in
Password Protection Mode.
Screen will read "Enter Password" if any button other
than the
Key icon displayed in the upper left side of the
screen when Password Protection is on.
INTELLIFLO Variable Speed Pump Installation and User's Guide
®
arrows to scroll to "Device"
.
arrows to scroll to "Temperature
.
arrows to choose Celsius (°C) or
when the pump is off will return
button is pressed
Password
Protection
Enabled
9