Connecting To An Automation System; Communication Center - Pentair INTELLIFLO Installation And User Manual

Variable speed pump

Hide thumbs Also See for INTELLIFLO:

Installation and user manual (36 pages)

Operation and set up instructions (16 pages)

Installation manual (4 pages)

Table Of Contents

Table of Contents

Use the RS-485 communications cable to remotely

control the IntelliFlo

Variable Speed Pump from an

IntelliComm communication center. The IntelliComm

system provides four (4) pairs of input terminal

connections. These inputs are actuated by either 15

- 240 VAC or 15 - 100 VDC. Use the device inputs, to

control the programmed pump speeds.

For the pump to accept commands from the

IntelliComm system, the pump must be in the

"Running Schedules" mode (LED above Start/Stop

button is on). If more than one input is active, the

highest number will be communicated to the pump.

The IntelliComm system will always communicate to

pump using ADDRESS #1.

If programs 1 and 2 are activated, program 2 will

run, regardless of the assigned speed (RPM). The

higher program number will always take priority.

External Control is for programming speeds that will

run when the IntelliComm communication center

controller sends it a command.

For example, Terminal 3 and 4 in IntelliComm

system will correspond to External Control Program

#1. (5 and 6 to Ext Ctrl #2). Use the External Control

feature to program the IntelliComm communication

center.

The pump can be controlled by an EasyTouch or

IntelliTouch system via the RS-485 communication

cable. The EasyTouch and/or IntelliTouch control

system starts, stops and controls the speed of the

pump.

EasyTouch and/or IntelliTouch systems rewrite the

pump memory when a command is given. This can

take several seconds and can cause a delay until the

pump physically responds.

The pump control panel is disabled when

communicating with an EasyTouch and/or IntelliTouch

system.

address is "1" (only address for EasyTouch system).