Thermal Mode - Pentair INTELLIFLO Installation And User Manual

16
The sensor for Thermal Mode is in the drive, on top
of the motor. This feature allows you to set a speed
(450 RPM - 3450 RPM) that runs when the IntelliFlo
Variable Speed Pump goes into Thermal Mode. The
temperature level that you wish Thermal Mode to start
can also be set.
This feature is for protection of the
pump. Do not depend on the Thermal Mode feature for
freeze protection of the pool. Certain situations could
cause the pump to sense a different temperature than
actual air temperature.
Your automation systems air temperature sensor should
be used to sense actual temperature. For example, if
the pump is located indoors, the temperature of the
room does not indicate the outdoor temperature. The
pump does not sense the water temperature.
1. Check that the green power LED is on.
2. Press .
3. Use the arrow to scroll to "Thermal Mode"
and press .
4. The factory default for Thermal Mode is
"Enabled". To disable Thermal Mode, press
to highlight "Enabled".
5. Press the arrow - "Disabled" is displayed.
6. Press to save.
Setting the Thermal Mode Pump Speed
INTELLIFLO Variable Speed Pump Installation and User's Guide
®
Set Speed (750 RPM - 3450 RPM) Default 1000 RPM
Thermal Mode features are only accessible if
®
Thermal Mode is "Enabled".
1. With "Thermal Mode" displayed on the screen,
press the
The factory default is 1000 RPM.
2. Press
3. Use the
3450 RPM).
4. Press
5. Press the
temperature the pump will activate Thermal Mode,
default is 40° F/4.4° C).
6. Press
F (4.4° C - 10° C).
7. Press
To cancel any changes, press
without saving.
8. Press
Setting the Thermal Mode Pump Temperature
Set Speed (750 RPM - 3450 RPM) Default 1000 RPM
Thermal Mode Menu Options
arrow - "Set Speed" is displayed.
to change the speed. The cursor will
or arrows to set speed (450 -
to save the speed.
arrow to Pump Temperature
to change the setting. The cursor will
to save the temperature setting.
to exit.
(the
40° F to 50°
to exit