V2 Zariss Series Manual page 60

DISPLAY DATA
LUCi
CiCL
no
t.LUC
AUS
Mon
tiM
biSt
SPiA
FLSh
W.L
no
LP.PA
no
Si
St.rt
StAn
no
AP.Ch
PrES
oroL
StoP
no
ProS
invE
DESCRIPTION
Courtesy lights
This menu allows setting the automatic operating of the courtesy lights during
the opening cycle of the gate.
NOTE: If the output is used to drive a flashing light (with internal flasher)
CiCL
select
Light on for the entire duration of the cycle
Function deactivated
Timed function (from 0 to 20')
Auxiliary channel
This menu allows setting the operating of the relay of the lighting of the
courtesy lights by means of a remote control stored on the channel 4 of
the receiver
Monostable operation
Timed function (from 0 to 20')
Bistable operation
Setting low voltage exit lights
This menu makes to possible to set the flashing exit function.
Flasher operation (fixed frequency)
Indicator light operation: Indicates the status of the gate in real-time. The type
of blinking indicates the four possible conditions:
- GATE STOPPED: Light off
- GATE IN PAUSE: the light is on, fixed
- GATE OPENING: the light blinks slowly (2 Hz)
- GATE CLOSING: the light blinks quickly (4 Hz)
Function deactivated
Blinker during pause time
Function deactivated
The blinker will be on during the pause time too (gate open with automatic
closure active).
Activation inputs (START and START P.)
PD12 control unit is equipped with two activation inputs, whose operation
depends on the programmed operation modes (see chapter 4.7):
Standard mode
Start inputs from terminal board are disabled.
Radio inputs operate in standard mode
Open/Close command
Manned operation
Timer mode
Stop Input
The input STOP is not available
The input STOP stops the gate: pressing the command START the gate
continues the motion
The command STOP stops the gate: at the next START the gate starts moving
in the opposite direction
58
DEFAULT MEMO
CiCL
Mon
FLSh
no
StAn
no