V2 Zariss Series Manual page 56

12 - PROGRAMMING THE
CONTROL UNIT
The configuration menu -PrG consists in a list of configurable
items; the display shows the selected item.
By pressing i, you will pass to the next item; by pressing , you
will return to the previous item.
By pressing OK, you can view the current value of selected
item and possibly change it.
The last menu item (FinE ) allows storing the carried out changes
and going back to the control unit normal operation.
You must exit from programming mode through this menu item
if you do not want to lose your configuration.
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
By holding down the i key, configuration menu items will scroll
fast, until item FinE is viewed. Viceversa, by holding down
the key, items will scroll fast backwards until item En.SA is
viewed.
In this way, you can quickly reach either the top or bottom of the
list.
There are the following three kinds of menu items:
• Function menu
• Time menu
• Value menu
Function menu setup
Function menus allow selecting a function from among a group
of available options. When you enter into a function menu, the
current active option will be viewed; you can scroll all available
options through i and
activate the option viewed and you will return to the
configuration menu.
Time menu setup
Time menus allow setting a function duration. When you enter
into a time menu, the current setup value will be viewed.
Each time you press key, current time value increases and each
time you press the i key, current time value decreases.
By holding down the key, you can quickly increase the time
value, up to reach the max. value allowed for this item. Vice
versa, by holding down the i key, you can quickly decrease
the time value down to reach 0.0 ".
In some circumstances, setting the value to 0 means that the
relevant function is disabled, in this case, 'no' will appear instead
of 0.0 ".
By pressing on OK you will confirm the displayed value and
you will return to the configuration menu.
Value menu setup
Value menus are similar to time menus; however, the setup value
can be any number.
or i keys, the value will increase or
By holding down
decrease slowly.
PLEASE NOTE: in the following description, Motor 1 is
associated with the superior gate leaf (the one that opens
first), while motor 2 is associated with the inferior gate
leaf (the one that closes first) in accordance with that
established in the initialisation procedure.
54
keys. By pressing the OK key, you will