V2 Zariss Series Manual page 39

3.2 - INSTALLATION MEASURES
To carry out a proper installation of the operator parts as well as to ensure the best automation performance, the measurement
levels shown in the following table shall be complied with. Change the gate structure to adapt it to one of the cases in the table, if
necessary.
1. Depending on the opening angle of the leaves or panels, make sure it is possible to respect the dimensions reported in the table
2. Measure the value of B on-site
3. Based on the value for dimension B and the opening angle of the leaves or panels, the value of A may be deduced from the table
PLEASE NOTE: ensure there are no obstacles near the motor that might interfere with the arm, both during movement
and with the gate open.
B
0 ÷ 60
60 ÷ 150
150 ÷ 180
90°
180 ÷ 210
210 ÷ 230
230 ÷ 250
B
0 ÷ 50
50 ÷ 100
100 ÷ 130
100°
130 ÷ 150
150 ÷ 170
170 ÷ 200
B
0 ÷ 20
20 ÷ 30
30 ÷ 40
50 ÷ 60
110°
60 ÷ 70
70 ÷ 80
80 ÷ 90
90 ÷ 110
37
A C D
120 450 615
130 480 590
140 500 570
150 500 550
160 500 530
170 500 510
A C D
170 540 590
180 560 550
180 570 545
180 580 540
190 580 520
200 580 500
A C D
210 610 545
220 620 525
230 630 510
240 630 500
250 630 485
260 650 475
270 660 465
280 660 450