Table of Contents
Advertisement
1
Press and hold the SHIFT button until the words "ENTER CODE" appear.
2
Type in the numbers "1-8-6-7" by using the source buttons 1-8 (one being the first source
on the left and 8 being the first source to the right).
3
Press SHIFT button again. The keypad will read "PROGRAM MODE".
4
Press the TREBLE UP button to advance the keypad's display to read the next room
name and its status or the TREBLE DN button to go back to the previous room and its
status. If the keypad is designed to operate a home theater, the TIME DELAY button
sits in place of the TREBLE UP button and the MONO ENHAN button sits in place of
the TEBLE DN button. Please note, if the keypad does not display either NEXT ROOM
or PREVIOUS ROOM, the keypad has automatically timed out of the program mode.
You will need to reenter the code by following Step 1 in this section again.
5
When the correct room name has been displayed (the room name only appears for a
moment and then the display indicates the room's status), press the << button. The
display will read "ROOM CHANGED" and then the keypad will reset to its normal
operational mode. At this point the keypad should correctly be able to select sources
95
Hide quick links:
Advertisement
Table of Contents
