Ada Delta-88 Manual page 88

Delta System Installation (cont.)
2d PCT-8/PCT-4 Trouble-Shooting - Verifying MC-3000 or MC-3800 Programming
If the keypads do not respond or feedback information from the PCT-4 or PCT-8 and the
address settings are correct, you will want to make certain that the MC-3000 or MC-3800 did
in fact program from the Delta-88 as discussed in section 2a steps 10 and 11. To check the
keypad follow these steps.
1 On the keypad, press and hold the SHIFT button until the words "ENTER CODE"
appear.
2 Enter the program code 1-8-6-7 using the keypad's source buttons (1-8, left to right). The
numbers will appear on the keypad as the appropriate source button is pressed. If you
pressed in a wrong number, continue typing in the correct number as the enter code
function only scrolls through the four access code numbers.
3 Press the SHIFT button again. The keypad will indicate that access to the program mode
has been granted by displaying "PROGRAM MODE". Please note, that the keypad will
automatically time-out of the program mode if no buttons are pressed over a five second
interval. If this occurs you will need to repeat step 2.
4 Press the BASS UP (or MODE - home theater keypads) button until "CHECK SETUP"
appears.
5 Press the source buttons one at a time. The display will read the keypad's source
button's address as programmed from the Delta-88 (i.e. "PCT8 1 OUT 2").
Take careful note as to the addresses displayed on the keypad during the "Check Setup"
procedure. If the addresses differ from the PCT-8/PCT-4 or Delta-88, two things may have
occurred.
i If the keypad's source buttons display a different address from the same source buttons
on the Delta-88, the keypad may have not been fully loaded with the Delta-88's program
as discussed in steps 10 and 11 of the previous section. You will need to repeat these two
steps.
ii The keypad's source address matches the Delta-88s source address but these addresses
differ from the PCT-8 or PCT-4 address. If the source address is wrong or if the source
address does not in any way match the above format you will need to change the Delta's
source address as discussed in the previous section steps 1-9.
2e PCT-8/PCT-4 Trouble-Shooting - Keypad Display Reads Wrong Label
If the keypad is displaying a transport label but it is the wrong label, two things may have
occurred.
88