Updates; Connecting Bluetooth Module; Troubleshooting; Errors After Connecting The Battery - KONTRONIK KOLIBRI 60 LV Operation Manual

8. Updates

You can update your KOLIBRI firmware online
without sending it to KONTRONIK, if the following
requirements are met:
•
KOLIBRI ESC
•
KONTRONIK Programming unit
•
PC with Windows ™ operating system
•
Internet connection
•
Battery (2S - 6S)
Disconnect the KOLIBRI from your receiver
1.
(slave also) and connect the programming unit
to the KOLIBRI.
Plug the programming unit to a Windows ™ PC
2.
and connect to the Internet.
Download the latest software version for your
3.
ESC from our
(www.kontronik.com) and save the file to your
PC.
Connect the KOLIBRI to a suitable battery (2S
4.
- 6S) and switch on the programming unit.
Run the update from your PC by double-
5.
clicking the downloaded file.
When connecting
6.
programming unit, the currently installed
software version is shown in the screen output
of the update software.
When the PC and the programming unit
7.
recognize the connected KOLIBRI, the update
button in your programming unit appears
selectable.
The update runs automatically. During the
8.
update none of these existing connections must
be separated.
When the update is completed successfully a
9.
confirmation of the new software version
appears on the programming unit's display.
After a successfully completed update all
10.
connections can be disconnected, the KOLIBRI
is ready for use.
Attention: after updating a reset has to be
done (KONTRONIK Programming unit or
!
Mode 1). Otherwise the ESC looks dead. All
previously made preferences will be reset,
the mode programming must be redone.
KONTRONIK homepage
the KOLIBRI to
9. Connecting the Bluetooth Module
To connect the Bluetooth Module follow this:
1. finish Mode programming
2. disconnect battery
3. Connect Bluetooth Module and conduct
pairing (see manual of the Bluetooth
Module).
4. After the configuration of the module you
can use K-Prog and K-View

10. Troubleshooting

There are three different options for errors:
•
error after connecting the battery (selftest)
•
error during the operation
•
warnings
10.1 Error after connecting the battery
The KOLIBRI ESC's is doing a selftest every time it
is connected to a battery.
Selftest error: LED green is off, LED red is flashing:
blink-
description
code
the
Error at motor connection
1
(internal)
Error at motor connection
2
(external)
Short circuit at battery connectors
3
(plus and minus switched)
4 Overvoltagefuse detected
5 Battery overvoltage / undervoltage
6 BEC overvoltage / undervoltage
BEC/MOS Fet's-Overtemperature
7
8 EEProm error
process
Please send in
Please check motor
connections
Please send in
Please send in
Please check battery
voltage
Please send in
Please send in
Please repeat modus
programming
25