Table of Contents
Advertisement
Carrying strap
A carrying strap
(34) (Fig 6)
On the lower moulding of the leg with the strap, drive in the 'knock-out'
able tool. If possible, remove the blank from inside the moulding to prevent subsequent rat-
tle.
Push a blind captive nut
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
Install a washer
(34.3)
(34.4). Ensure that the hole in the strap anchor is oriented so that the
be attached.
On the underside of the tripod bowl (20), remove and discard the screw
corresponding leg clamp (20.2). Do not remove the washer (20.1).
Position the bowl strap anchor
ing Loctite 221, secure the bowl strap anchor with the 25 mm M6 screw
the strap. Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners (34.1), clip the strap
Optional equipment
is available as an optional accessory and is installed as follows:
(34.4)
into the hole in the lower moulding.
on the lower strap anchor
(34.6)
on the leg clamp, ensuring it is correctly oriented. Us-
(34)
to the strap anchors and adjust to length.
(25.1)
(34.2)
and screw into the captive nut
karabiner(34.1)
(34.5)
(34.5)
Back
using a suit-
can
securing the
supplied with
20
Hide quick links:
Advertisement
Table of Contents
