Table of Contents
Advertisement
Tilt brake knob adjustment
Because its movement is restricted, the tilt drag knob
longed use:
To adjust the tilt brake knob:
Slide off the rubber tilt drag knob
Loosen the drag clamp grubscrew
drag shaft (3.3).
Loosen the brake clamp grubscrew
shaft (4.2).
Turn the brake shaft
Install the knob
(4)
tical, pointing downward toward the rear of the head, or as suitable to the operator.
Turn the knob fully clockwise and ensure that the brake is released. Turn the knob counter-
clockwise and ensure the brake is applied at a suitable position before the knob interferes
with other head controls.
Readjust as necessary and secure the knob with the clamp grubscrew (4.1).
Refit the drag knob actuator
screw (3.2).
Push the rubber drag knob
(3)
as shown in
(3.2)
and remove the drag knob actuator
(4.1)
and remove the tilt brake knob
(4.2)
counterclockwise until the tilt brake is fully applied.
on the brake shaft
(4.2)
with the lever approximately 30° - 45° past ver-
(3.1)
onto the drag shaft
(3)
back onto the actuator (3.1).
(4)
may also require adjustment after pro-
(Fig
8).
(4)
(3.3)
and secure with the clamp grub-
Back
(3.1)
from the
from the brake
25
Hide quick links:
Advertisement
Table of Contents
