Table of Contents
Advertisement
To remove the spreader, press in the attachment release buttons
in turn.
To adjust the mid-level spreader:
There are two spread settings. To select maximum (flat) spread, lift the spreader centre
moulding such that lugs can pass the extension arms, and rotate the spread knob
clockwise. To select minimum (45°) spread, lift the spreader centre moulding and rotate the
spread knob
(28)
fully anticlockwise.
NOTE:
The spread knob
spreader centre moulding to allow the knob
A pointer on the knob
Extension arms can be individually adjusted by releasing the extension clamps (29), ex-
tending the arm as required and re-tightening the clamp (29).
NOTE:
Do NOT attempt to fold the tripod if the spreader extension arms are uneven
lengths.
Set all extension arms to the same length
To adjust the tripod:
Adjust the operating height by undoing the leg clamps
desired height. Adjust the spreader
Tighten the clamps
locked position.
In adverse conditions secure the tripod using the tie-down hook (27), or suspend a weight
from the hook.
WARNING! Use care when the tripod is fully extended and the floor
(28)
will not rotate when the spreader is loaded. Lift the
(28)
indicates maximum or minimum spread setting.
(29)
if necessary.
(21)
until an audible click is heard and the knob is in the horizontal,
spreader is in the closed position, as stability will be reduced.
(30)
and free each arm
(28)
to rotate freely.
(29)
and then fold the tripod.
(21)
and pulling the tripod up to the
Back
(28)
fully
15
Hide quick links:
Advertisement
Table of Contents
