Optional Equipment; Carrying Strap; Dollies - Vinten protouch PRO-6HDV Operator's Manual

Carrying strap

(Fig 6)
A carrying strap (34) is available as an optional accessory and is installed as follows:
On the lower moulding of the leg with the strap, drive in the 'knock-out' (25.1) using a suitable tool.
If possible, remove the blank from inside the moulding to prevent subsequent rattle.
Push a blind captive nut (34.4) into the hole in the lower moulding.
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
Install a washer (34.3) on the lower strap anchor (34.2) and screw into the captive nut (34.4). En-
sure that the hole in the strap anchor is oriented so that the karabiner (34.1) can be attached.
On the underside of the tripod bowl (20), remove and discard the screw (34.5) securing the corre-
sponding leg clamp (20.2). Do not remove the washer (20.1).
Position the bowl strap anchor (34.6) on the leg clamp, ensuring it is correctly oriented. Using Loc-
tite 221, secure the bowl strap anchor with the 25 mm M6 screw (34.5) supplied with the strap.
Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners (34.1), clip the strap (34) to the strap anchors and adjust to length.

Dollies

HDV
The PRO-6 system may be mounted on a variety of OB and studio dollies, which are listed under 'Op-
tional accessories' on page 19.

Optional equipment

English
15