Optional Equipment; Carrying Strap; Dollies - Vinten PRO-5Plus Operator's Manual

Carrying strap

A carrying strap (26) is available as an optional accessory and is installed as follows
On the lower moulding of the leg with the strap, drive in the 'knock-out'
able tool. If possible, remove the blank from inside the moulding to prevent subsequent rat-
tle.
Push a blind captive nut
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
Install a washer
(26.4). Ensure that the hole in the strap anchor is oriented so that the karabiner
be attached.
On the underside of the tripod bowl (18), remove and discard the screw
corresponding leg clamp (18.2). Do not remove the washer (18.1).
Position the bowl strap anchor
ing Loctite 221, secure the bowl strap anchor
plied with the strap. Tighten screw to a torque of 4.5 Nm (40 lbf in.).
Using the karabiners (26.1), clip the strap

Dollies

plus
The PRO-5 system may be mounted on a variety of OB and studio dollies, which are listed un-
der Optional accessories

Optional equipment

(26.4) into the hole in the lower moulding.
(26.3) on the lower strap anchor
(26.6) on the leg clamp, ensuring it is correctly oriented. Us-
on page 24.
(26.2) and screw into the captive nut
(26.6) with the 25 mm M6 screw
(26) to the strap anchors and adjust to length.
Back
(Fig. 6):
(23.1) using a suit-
(26.1) can
(26.5) securing the
(26.5) sup-
18