VERITAS NetBackup 5330 Hardware Service Procedure page 7

HSP 137 Replacing a disk drive in a Primary Storage Shelf or an Expansion Storage Shelf
5 Use the handle to lift the drive out of the drive slot.
6 Place the disk drive in an ESD-compliant wrapper.
7 If you remove multiple drives, label each drive with the storage shelf number, the drive drawer
number, and the slot number.
To install the storage-shelf disk drive
1 Remove the replacement drive from the ESD-protective bag.
2 Raise the drive handle on the new drive to the vertical position.
3 Align the two raised buttons on each side of the drive over the matching gap in the channel on
the drive drawer.
4 Lower the drive straight down then rotate the drive handle down until the drive snaps into place
under the drive release lever.
7