VERITAS NetBackup 5330 Hardware Service Procedure page 5

Hide thumbs Also See for NetBackup 5330:

HSP 137 Replacing a disk drive in a Primary Storage Shelf or an Expansion Storage Shelf

Locate the drawer the faulty drive is in and pull both orange release levers into the center. The

release levers are located at both ends of the drawer on the bottom.

Pull the drawer out to the full extension.

To remove a storage-shelf disk drive

Put on an ESD-compliant wrist strap or take other ESD-protective measures.

Note: The static discharged by human bodies can damage static-sensitive components on the

boards. When installing and maintaining the equipment, you must observe appropriate electrostatic

safety precautions to prevent personnel injuries or device damage.

To review electrostatic safety precautions, see the topic titled Electrical Safety found earlier in

this document.

Each drive has two LEDs that indicate Status and Service Action Allowed. The failed drive is

indicated by a yellow status LED and a blue Service Action Allowed LED.

Velocity 7330