Steps Required After Ovs Installation; Setting The Date, Time And Time Zone On The Server - Avid Technology FastServe Live Edit Setup Manual

Steps Required After OVS Installation

The following table provides a checklist of tasks that must be performed after installing Avid OVS
for the first time on a FastServe | Live Edit or FastServe | Ingest server.
b
Set the date, time, and time zone settings, as described in the topic
Zone on the Server" on page
b
Set the CPU speed, as described in the topic
b
Update the modeprobe.conf file, as described in the topic
page 51.
b
Edit the Codecs file, as described in the topic
b
Update your license, as described in the topic
b
Edit the vsPreferences.cfg file, as described in the topic
page 54.
b
Update the firmware of DVG boards, as described in the topic
on page 53.
b
Update the Avid registry, as described in the topic

Setting the Date, Time and Time Zone on the Server

You need to correctly set the date, time and time zone on each FastServe server.
To set the date, time and timezone options:
1. After installing the OVS, you need make sure to stop it before changing its parameters. Use the
following command to stop it:
/data/VS/bin/set_run -s all
2. To display the current time and date on your system, use the following commands:
timedatectl status
hwclock
3. If required, disable NTP (Network Time Protocol) and RTC (Real-time clock):
timedatectl set-local-rtc 0
timedatectl set-ntp 0
4. Check the current time zone:
ls -l /etc/localtime
timedatectl | grep -i 'time zone'
5. Change the time zone to the one you require (we will use Europe/ Warsaw and Asia/Jerusalem as
an example):
timedatectl set-timezone Europe/Warsaw
timedatectl set-timezone Asia/Jerusalem
6. Verify your time zone settings by typing the following commands:
ls -l /etc/localtime
timedatectl | grep -i 'time zone'
50.
"Setting the CPU Speed" on page
"Editing the Codecs File" on page
"Updating Your License" on page
"Editing the vsPreferences.cfg File" on
"Updating the AvidRegistry" on page
50
"Setting the Date, Time and Time
51.
"Updating the modprobe.conf File" on
51.
53.
"Updating Firmware of DVG Boards"
57.