Procedure 6. Use The Recording Feature (Optional) - Verathon GlideScope Cobalt AVL Single-Use Operation & Maintenance Manual

PROCEdURE 6.
WARNING
Use only passive‑mode USB flash drives provided by Verathon
recognize some flash drives from other manufacturers. Never use USB drives powered by an
external power source.
The GlideScope AVL monitor contains enough internal memory to record about 60 minutes of video. Under
typical conditions, this is equivalent to about 40 intubation procedures. If you start a new recording and
the video monitor has run out of memory, it deletes the oldest recordings automatically until it has created
enough space. Because of this, you should download your recordings to an external USB flash drive regularly
in order to preserve them.
MAKING A NEW RECORdING
1. After setting up the GlideScope system, press the Record button
2. When you want to stop recording, press the Record button
3. Wait for the Saving File
dOWNLOAdING RECORdINGS TO A USB FLASH dRIVE
4. Make sure that the flash drive has at least 1 GB of available space.
5. On the back of the monitor, remove the USB port cap, and then insert the USB flash drive into the port.
6. Press the Download Video button
appear on the screen.
Operations & Maintenance Manual: Using the Device
USE THE RECORdING FEATURE (OPTIONAL)
icon to disappear from the screen before starting a new recording.
USB port
, ensuring that the USB Flash Drive Not Found
. The monitor may not
®
in order to begin the recording.
again.
icon does not
31