Presser Foot Pressure - KANSAI SPECIAL DLR-1501SPF Instruction

【9】ADJUSTING THE PRESSER FOOT

9-1 Presser foot pressure

The presser foot pressure should be as light as
possible, yet be sufficient to feed the fabric and
produce uniform stitches.
To increase the presser foot pressure, turn the
adjusting knob clockwise (see the illustration).
9-2 Position of the presser foot and foot lift
Fit the presser foot properly onto the presser bar.
Make sure the needle drops correctly to the center of
the needle drop hole on the presser foot.
Adjustment is made by loosening screw A.
■Foot lift
The presser foot should be 7~9mm above the top
surface of the needle plate.
■Set stopper B at the required position.
Fasten the presser foot lift lever with nut C so that
the lever cannot be lowered.
11