Adjustment (Electric Type); Height Of Cutter; Overlapping Of Cutter; Power Of Upper Cutter - KANSAI SPECIAL MC 30 Instruction Manual

【 2】 ADJUSTMENT（ ELECTRIC TYPE）

2 2 2 2 - - - - 1 Height of Cutter

1 Height of Cutter
1 Height of Cutter 1 Height of Cutter
Loosen screw E and adjust lever F in order to set
24 mm of the distance between lower cutter and
upper cutter at the top position (top dead point).
During this adjustment, do not forget to align
between surface G (surface of lever F) and edge
surface of solenoid shaft.
＜ Note ＞
After adjusting, drop down upper cutter at the bottom
position ( bottom dead point ) in pulling lever F
direction to H. Then, confirm whether upper cutter
and lower cutter shall meet each other at 1 mm
distance or not.

2 2 2 2 - - - - 2 Overlapping of Cutter

2 Overlapping of Cutter
2 Overlapping of Cutter 2 Overlapping of Cutter
1. Loosen screw I, then loosen screw J until
disappearing of pressurized power of upper
cutter.
2. Loosen screw K, then adjust screw L in order
to overlap properly between upper cutter and
lower cutter.
＜ Note ＞
When checking the proper overlapping between upper
cutter and lower cutter, move upper cutter by your
hand.

2 2 2 2 - - - - 3 3 3 3 Power of Upper Cutter

Power of Upper Cutter Power of Upper Cutter Power of Upper Cutter
After loosen screw I, then adjust the pressurized
power of upper cutter against lower cutter by screw
J.
2