Remote Controller; Preparation - Kenwood DDX7019BT Instruction Manual

Remote Controller

Remote Controller
You can operate the unit using the remote controller
(RC-DV340) supplied with this unit.
• DMX7019BT Australian/New Zealand models/
DMX719WBT Australian/New Zealand models:
Optional remote controller KNA-RCDV331 is
designed for controlling this unit. Refer also to
the instruction manual supplied with the remote
controller.
DDX7019BT/DDX7019BTM/DMX7019BT/
DMX7019BTM
DDX719WBT/DDX719WBTM/DMX719WBT/
DMX719WBTM
* Remote sensor: DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Point the remote controller directly at the remote
sensor on the monitor panel.
CAUTION
• Put the remote controller in a place where it will
not move during braking or other operations. A
dangerous situation could result if the remote
controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery,
or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in
contact with your eyes or clothing, immediately rinse
with water and consult a physician.
• Place the battery out of reach of children. In the
unlikely event that a child swallows the battery,
immediately consult a physician.

Preparation

Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
• Always insert batteries from – poles to avoid bending
the springs.
• If the remote controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace
both batteries with new ones.
ENGLISH 45