Installing The Unit - Kenwood DDX7019BT Instruction Manual

Installation and Connection Installation and Connection
Parts list for installation
Note:
• This parts list does not include all the package
contents.
• Items " is supplied only for DDX7019BT/
DDX7019BTM/DMX7019BT/DMX7019BTM.
• Item ] is supplied only for DMX7019BT Australian/
New Zealand models.
• Item ' is supplied only for DDX7019BTM/
DMX7019BTM/DMX7019BT Australian/New Zealand
models/DDX719WBT/DDX719WBTM/
DMX719WBT/DMX719WBTM.
¥ Wiring harness (× 1)
ø Extension parking cable, 2 m (× 1)
π Steering wheel remote input cable (× 1)
[ Round head screws, M5 × 8 mm (× 6)
" Flat head screws, M5 × 8 mm (× 6)
] Trim plate (× 1)
' Microphone, 3 m (× 1)
50 ENGLISH
Installation procedure
1
Remove the key from the ignition and
disconnect the battery.
·
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness to the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7
Reconnect the battery.
·
8
Configure <Initial SET-UP>. (Page 6)

Installing the unit

Installing the unit using the mounting
bracket removed from the car
[ / "
Note: Select the appropriate screws (supplied) for the
mounting bracket.
Installing the trim plate
(Only for DMX7019BT Australian/New Zealand
models)
[ / "
Car bracket