Kenwood DDX7019BT Instruction Manual page 40

Settings Settings
<Fader/Balance>
Touch [ J ]/[ K ]/[ H ]/[ I ] or drag the
<Fader>*
Adjusts the front and rear speaker output balance.
When using a 2-way speaker system, set the fader to
the center.
• Front 1 to Front 15, Center, Rear 1 to Rear 15
(Initial: Center)
* Adjustable only when <X'over Network> is set to [2way].
(Page 34)
<Balance>
Adjusts the left and right speaker output balance.
• Left 1 to Left 15, Center, Right 1 to Right 15
(Initial: Center)
To clear the adjustment: Touch [Center].
<Volume Offset>
Adjust and store the auto-adjustment volume level
for each source. The volume level will automatically
increase or decrease when you change the source.
If you have increased the volume first, then reduced
the volume using the Volume Offset, the sound
generated if you suddenly switch to another source
may be extremely loud.
• –5 to +5 (Initial: 0)
To initialize the setting value: Touch [Initialise].
38 ENGLISH
<Sound Effect>
mark to adjust. Adjust the sound effect.
<Bass Boost>
Selects the bass boost level.
• OFF (Initial)/1/2/3
<Loudness>
Adjusts loudness. (The LOUD indicator lights up when
the loudness is adjusted.)
• OFF (Initial)/Low/High
<Drive Equalizer>
Reduces the driving noise by raising the bandwidth.
• OFF (Initial)/ON
<Space Enhancer>*
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system. Select the enhance
level.
• OFF (Initial)/Small/Medium/Large
* You cannot change the setting when "Radio" is selected as the
source.
<Supreme>
Restores the sound lost due to audio compression to a
realistic sound.
• OFF/ON (Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/1/2/3
<Stage EQ>
Moves the localization of the sound image to the
lower or higher point. Select the height.
• OFF (Initial)/Low/Middle/High