Remote Controller; Battery Installation; Remote Controller Mode Switch - Kenwood DDX630BT Instruction Manual

Remote Controller

This unit can be operated using the Remote Controller (RC-DV340) supplied with this unit.
¤
CAUTION
• Put the Remote Controller in a place where it will not
move during braking or other operations. A dangerous
situation could result, if the Remote Controller falls down
and gets wedged under the pedals while driving.
• Do not leave the battery near fire or under direct sunlight.
A fire, explosion or excessive heat generation may result.
• Do not recharge, short, break up or heat the battery or
place it in an open fire. Such actions may cause the battery
to leak fluid. If spilled fluid comes in contact with your eyes
or on clothing, immediately rinse with water and consult a
physician.
• Place the battery out of reach of children. In the unlikely
event that a child swallows the battery, immediately
consult a physician.
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.

Battery installation

Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
⁄
• If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace the
both batteries with new ones.
74 DDX630BT

Remote Controller mode switch

The functions operated from the remote
controller differ depending on the position of the
mode switch.
DISP
SRC V.SEL
MODE FNC/PBC
TOP MENU MENU DVD SETUP RETURN
AUDIO SUBTITLE ANGLE ZOOM
AUD
AUD
DVD
DVD
ENTER
T V
T V
+
AM − OPEN
FM
VOL
1 2 3
2 ZONE
ABC DEF
4 5 6
GHI JKL MNO
R.VOL
7 8 9
PQRS TUV WXYZ
0
CLEAR DIRECT ATT
AUD mode
Switch to this mode when controlling a selected
source or tuner source, etc.
DVD mode
Switch to this mode when playing DVDs or CDs etc.
with the player integrated in this unit.
TV mode
Switch to this mode when controlling TV.
⁄
• The position of the remote control mode switch is
indicated in the title of each mode, e.g., "(AUD mode)".
• When controlling a player that is not integrated in the
unit, select "AUD" mode.