Remote Controller; Preparation - Kenwood DDX4018DAB Instruction Manual

Settings Settings
Connect a USB device with the update file to the unit.
<Application Version>
Updates the system application.
<System Version>
Updates the system.
<DVD Version>
Updates the DVD system application.
<DAB module Version>*
Updates the Digital Radio (DAB) module application.
* Only for DDX4018DAB.
The system update starts. It may take a while.
If the update has been completed successfully,
"Update Completed" appears, then reset the unit.
• Do not disconnect the USB device while updating.
• If the update has failed, turn the power off and then
on, and retry the update.
• Even if you have turned off the power during the
update, you can restart the update after the power
is turned on. The update will be performed from the
beginning.
<Open Source Licenses>
Shows the Open Source Licenses.
40 ENGLISH

Remote Controller

Remote Controller
You can use an optionally purchased remote
controller, KNA-RCDV331, for controlling this unit.
• Refer to the instruction manual that comes with the
remote controller.
Remote sensor*
* DO NOT expose the remote sensor to bright
light (direct sunlight or artificial lighting).

Preparation

Battery installation
Use two "AAA"/"R03"-size
batteries.
Insert the batteries with the +
and – poles aligned properly,
following the illustration inside
the case.
• Always insert batteries from
– poles to avoid bending the
springs.
• If the Remote Controller
operates only over shorter distances or does not
operate at all, it is possible that the batteries are
depleted. In such instances, replace both batteries
with new ones.
Remote Controller mode switch
The functions operated from the remote controller
differ depending on the position of the mode switch.
• AUD mode: Switch to this mode when controlling a
selected source or tuner source, etc.
• DVD mode: Switch to this mode when playing DVDs
or CDs etc. with the player integrated in this unit.
• TV mode: Not used.
• NAV mode: Not used.