Wiring Connection - Kenwood DDX7019BT Instruction Manual

Installation and Connection Installation and Connection

Wiring connection

For DDX7019BT/DDX7019BTM/DDX719WBT (Indonesian models)
10 A fuse
Purple with white stripe
Light green
]
White / White with black stripe
Gray ] / Gray with black stripe
]
Green / Green with black stripe
Purple ] / Purple with black stripe
Brown
Orange with white stripe
Light blue with yellow stripe
Blue with white stripe (12 V
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
π
STEERING
REMOTE
USB1 input terminal (1 m)
(USB1) 5 V 1.5 A
To the car's reverse lamp harness when using the optional rear view camera
REVERSE
PRK SW
[
To front speakers /mid range speakers* (left)
[
To front speakers /mid range speakers* (right)
[
To rear speakers /tweeter speakers* (left)
[
To rear speakers /tweeter speakers* (right)
Not used.
MUTE
To the car light control switch
ILLUMI
STEERING WHEEL
REMOTE INPUT To the OE remote adapter (not supplied) which is compatible with your car
REMOTE CONT
350 mA)
To the power control terminal when using the optional power amplifier (Or)
ANT.CONT
P.CONT
To the control terminal of the motor antenna or to the power terminal for the booster amplifier of film-type antenna
Gray/Red
ST REMOTE
Connect to your vehicle's
GND
Bright green/Red
steering remote harness.
Input 1
Contact your KENWOOD
Purple/Red
dealer for details.
Input 2
Connect the antenna cord to the antenna terminal.
Extension parking cable ( ø )
To the car's parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
* For 3-way speaker system connection, see also page 55.
Ignition key switch
Car fuse
Car battery
To the car chassis
ENGLISH 51