Other External Components; View Camera - Kenwood DDX7019BT Instruction Manual

Other External Components

Other External Components

View camera

Install the view camera (separately purchased) in the
appropriate position according to the instructions
supplied with the view camera.
You can use both rear view camera and front view
camera.
Connecting a view camera
See page 55 for more information on connection
terminals.
• To use the rear view camera, a reverse lead (REVERSE)
connection is required. (Pages 51 – 54)
Using the view camera
• For view camera settings, see "Camera settings" on
page 42.
To display the rear view camera screen
The rear view camera screen is displayed by shifting
the gear to the reverse (R) position when [R-CAM
Interruption] is set to [ON] on the <Camera> screen.
(Page 42)
• A caution message appears on the screen. To
remove the caution message, touch the screen.
To display rear view camera screen manually
You can display the picture from the rear view camera
manually without shifting the gear to the reverse (R)
position.
Make sure <Front Camera> is set to [OFF].
(Page 42)
On the monitor panel:
DDX7019BT DDX719WBT
DDX7019BTM DDX719WBTM
DMX7019BT DMX719WBT
DMX7019BTM DMX719WBTM
On the pop-up short-cut menu (only for
DDX7019BT/DDX7019BTM):
Operations while the view camera screen is
displayed
To switch the screen between front view camera
and rear view camera
• Make sure <Front Camera> is set to [ON].
(Page 42)
Touch the area shown below.
To exit the view camera screen
Press HOME on the monitor panel or touch the area
shown below.
ENGLISH 25