Kenwood DDX7019BT Instruction Manual page 55

Installation and Connection Installation and Connection
For DDX719WBT (except for Indonesian models)/DDX719WBTM
10 A fuse
STEERING WHEEL
REMOTE INPUT
¥ Purple with white stripe
Light green
Blue with white stripe
(12 V 200 mA)
P.CONT
Brown
MUTE
Connector D: To the car's steering remote harness
D22
• Depending on the type of vehicle, it cannot be
D21 D23
connected.
Connect the antenna cord from the power cord (A)
to the antenna terminal.
USB1 input terminal (1 m)
(USB1) 5 V 1.5 A
To the car's reverse lamp harness when using the optional rear view camera
REVERSE
PRK SW
To the control terminal of the motor antenna or to the power
terminal for the booster amplifier of film-type antenna
Not used.
Connector B: To the car's harness
Connector A: To the car's harness
To the car's parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
Extension parking cable ( ø )
Pin Color and Function
A1 Orange/White: Dimmer
A2 Yellow: Battery
A3/A5 Blue: Antenna control (12 V
A A4 Red: Ignition (ACC)
A6 Black: Ground connection
A7/A8 White with black stripe
A9/A10 Gray with black stripe
B1/B2 Green with black stripe
B
B5/B6 Purple with black stripe
D21 White: Input 1
D D22 Red: Input 2
D23 Black: Ground
* For 3-way speaker system connection, see also page 55.
300 mA)
[ / White ] : Left speakers /mid range speakers* (front)
[ / Gray ] : Right speakers /mid range speakers* (front)
[ ]
/ Green : Left speakers /tweeter speakers* (rear)
[ ]
/ Purple : Right speakers /tweeter speakers* (rear)
ENGLISH 53