Operation; Main Switch; To Start The Product; Operating Mode Start - Husqvarna AUTOMOWER 420 Operator's Manual

4.1 Main switch

WARNING: Read the safety
instructions carefully before you start
the product.
WARNING: Keep your hands and feet
away from the rotating blades. Do not
put your hands or feet near to or below
the product when the motor is on.
WARNING: Do not use the product
when persons, especially children, or
animals are in the work area.
• Set the Main switch in the
the product.
• Set the Main switch in the
the product is not in use or before you do
inspection or maintenance on the product.

4.2 To start the product

1. Push the STOP button to open the hatch.
2. Set the Main switch to position
3. Enter the PIN code.
4. Push the START button.
5. Select the desired operating mode and
confirm with the OK button. Refer to
Operating mode Start on page 39 .
1201 - 004 - 25.03.2020

4 Operation

6.
Note: If the product is parked in the charging
station, the product only leaves the charging
station when the battery is fully charged and if the
schedule allows the product to operate.
Note: The first weeks after installation the
perceived sound level when cutting the grass
may be higher than expected. When the product
has cut the grass for some time, the perceived
sound level is much lower.
1 position to start

4.3 Operating mode Start

Push the START button to select the following
0 position when
operating modes:
•
•
•
•
1 .
4.3.1 Main area
Main area is the standard operating mode where
the product mows and charges automatically.
4.3.2 Secondary area
To mow secondary areas the operating mode
Secondary area must be selected. In this mode,
the operator must move the product manually
between the main area and the secondary area.
The product mows for a selected period of time
or until the battery is empty. When the battery is
empty, the product stops and the message
Needs manual charging shows in the product
display. Put the product in the charging station to
charge the battery. When the battery is charged,
Close the hatch.
Main area
Secondary area
Override schedule
Spot cutting
Operation - 39