Transportation, Storage And Disposal; Transportation; Storage; Disposal - Husqvarna AUTOMOWER 420 Operator's Manual

7 Transportation, storage and disposal

7.1 Transportation

The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.

7.2 Storage

• Fully charge the product. Refer to
the battery on page 40 .
• Switch off the product. Refer to
the product on page 40 .
• Clean the product. Refer to
product on page 42 .
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level
ground during storage, or use a wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a connector protection box.
Note: If you keep the charging station
outdoors, do not disconnect the power
supply and the connectors.
• Contact Husqvarna sales representative
about what accessories are available for
your product.

7.3 Disposal

• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the
To remove the battery on
battery, refer to
page 59 .
7.3.1 To remove the battery
CAUTION: Only remove the battery
when you dispose the product. When
you remove the warranty seal, the
Husqvarna warranty is no longer
applicable.
1201 - 004 - 25.03.2020
1.
2.
3.
4.
To charge
To switch off
Clean the
5.
6.
7.
8.
9.
10. Open the battery cover and remove the
Switch off the product. Refer to
the product on page 40 .
Pull out the grommet on the charging cable
at the very front of the product, and carefully
remove the connector.
Lift the cover, one corner at a time.
Remove the 14 screws with a Torx 20.
Lift the rear edge of the top section of the
chassis.
Disconnect the cable from the main circuit
board.
Remove the top section of the chassis.
Remove the 4 screws that hold the battery
with a Torx 20.
Disconnect the battery connection from the
main circuit board.
battery.
Transportation, storage and
To switch off
disposal - 59