Husqvarna AUTOMOWER 420 Operator's Manual page 14

CAUTION: Do not lift the product when
it is parked in the charging station. It
can damage the charging station
and/or the product. Push STOP and
pull the product out of the charging
station before lifting it.
To safely move from or within the work area:
1. Push the STOP button to stop the product.
2. Set the main switch in position
3. Carry the product by the handle with the
blade disc away from the body.
2.3.4 Maintenance
WARNING: The product must be
switched off before any maintenance is
done. Use the plug to disconnect the
charging station before any cleaning or
maintenance of the charging station or
the loop wire.
14 - Safety
0 .
Inspect the product weekly and replace any
damaged or worn parts. Refer to
page 42 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical
components in the product and the charging
station, we recommend that all connections to the
charging station are disconnected (power supply,
boundary wire and guide wire) if there is a risk of
a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked
AR, AL and G1/G2/G3.
2. Disconnect all connected wires and the
power supply.
3. Connect all the wires and the power supply
if there is no longer a risk of thunder. It is
WARNING: Use the plug to disconnect
the charging station before any
cleaning or maintenance of the
charging station or the loop wire.
CAUTION: Never use a high-pressure
washer or even running water to clean
the product. Never use solvents for
cleaning.
Maintenance on
1201 - 004 - 25.03.2020