Husqvarna AUTOMOWER 420 Operator's Manual page 33

4. Push the down arrow button.
5. Use the number buttons to select how
frequently the product must use each sector.
Set in percentage.
6. Push the BACK button.
3.12.8 Reversing distance
The reversing distance makes the product move
in reverse for a set distance, before the product
starts to cut the lawn. The factory setting is 60
cm / 2 ft.
3.12.8.1 To set the reversing distance
To get access to the menu
1. Do steps 1-3 in
on page 26 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Reversing distance .
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.12.9 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 31 cm / 13 in. You can select a
distance of 20-50 cm / 10-15 in.
Drive Past Wire distance is changed,
Note: If the
the distance will change along the boundary wire
everywhere in the work area.
3.12.9.1 To set the Drive Past Wire function
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Drive Past Wire .
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.12.10 Settings
In settings you can change the general settings
to your product.
1201 - 004 - 25.03.2020
3.12.10.1 Profiles
With the function Profiles, different sets of
product settings can be saved. This can be used
when one product is used for more than one work
areas and charging stations. The product settings
and the pairing with the charging stations are
saved in the profile and can easily be used again.
To save settings to a profile
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use profiles > Profile A, B, C.
3. Use the arrow buttons and the OK button to
select and save the profile.
Installation
4. Push the BACK button.
If settings have been changed but not saved, the
symbol * is shown beside the profile name.
To change the name of a profile
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure Settings
Profiles > Use profiles > Profile A, B, C. >
Rename.
3. Use the arrow buttons and the OK button to
select letters.
4. Push the BACK button to save the new
profile name.
To use a profile
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
Profiles > Use profiles > Profile A, B, C >
Select.
3. Push the BACK button.
To connect a new charging station to a profile
1. Save the settings in a profile to be used with
the original charging station. Do steps 1–4 in
To save settings to a profile on page 33 .
2. Put the product in the new charging station.
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
To get access to the menu
Settings >
To get access to the menu
To get access to the menu
Settings >
Security >
Installation - 33
>